System power on & power off

Central Unit and Sensor Unit

Central Unit and Sensor Unit can be powered on by pressing the power button located inside the central unit.

NOTE: The Sensor Unit must be connected with the provided ethernet cable before starting up since it gets powered through Central Unit via Power over Ethernet (PoE) connection. Central Unit and Sensor Unit are ready to operate within one minute after pressing the power button.

In normal operation there is no need to power off the system. Powering off is required only if:

• Electricity of the system is going to be switched off

• System is behaving abnormally, and troubleshooting suggests central unit power off/power on cycle